枣庄交叉滚子轴承支承座及固定法兰的设计

因交叉滚子轴承是薄壁小型结构，所以要充分考虑支承座或固定法兰的刚性。（如下图)当外圈是分割型时，如果支承座或固定法兰及固定螺栓的刚性不足，就不能均等地固定内环或外环，在承受力矩负荷时轴承将产生变形，因此，滚子的接触区域会变得不均匀,轴承的性能就会显著地降低。

Because the cross roller bearing is a thin-walled small structure,the rigidity of the support seat or fixed flange should be fully considered.(As shown in the figure below)When the outer ring is a split type,if the rigidity of the support seat or fixed flange and fixed bolt is insufficient,the inner or outer ring cannot be fixed evenly,and the bearing will deform when bearing the torque load.Therefore,the contact area of the roller will become uneven,and the performance of the bearing will be significantly reduced.

以上就是文章的大致内容了，如果您有交叉滚子轴承、转盘轴承相关的问题和需求，可以咨询洛阳千协轴承，我们主营：交叉滚子轴承，转盘回转支承轴承，YRT转台轴承，等截面薄壁轴承等，支持非标定制，交期短，欢迎来电咨询！

The above is the general content of the article.If you have problems and needs related to cross roller bearing and rotary table bearing,you can consult Luoyang Qianxie Bearing.Our main products include cross roller bearing,rotary table slewing bearing,YRT turntable bearing,equal-section thin-wall bearing,etc.,support non-standard customization,short delivery time,welcome to inquire!